DB/DC chimney bench bracket, concrete ceramic tiles

For proper installation you will need the following items:

• Climbing platform (from 40 to 300* cm)
• Platform cradle
• Platform strut (depending on the type of roofing)
• Platform connector (if you need to connect a longer row of platforms)
• Mounting screws to connect the individual components (you will receive them free of charge in the SMART package)
• Screws for attaching the bench to the structure (not included)

*Length of 300 cm only on request

Fastening the elements to each other and to the roof.

Roofcommunication brackets should be attached to the wooden roof structure with wood screws complying with PN-EN 14592+A1:2012. 8 mm x 60 mm screws for fixing the bracket to the roof can also be found in our store. The elements should be connected together using the screws (Ø 8 mm) included in the kit.

Chimney brackets are designed to create passageways across the roof slope. Chimney brackets must be attached to the roof at a distance of at least 80 cm. Note that this is the maximum distance allowed by the standard. More detailed information about the brackets and the number of fixing screws and their dimensions must be specified in the technical design.

Roof purlins complement the chimney bay system and are designed to create passageways along the roof slope. Roof purlins should be spaced alternately, allowing the roof to be walked on like a staircase. When designing the spacing between eaves, it is necessary to take into account the angle of the roof:

• For roofs with a slope of up to 30° - install tiles in every second row of tiles, at a distance of 70 cm from each other.
• For roofs with a slope of more than 30° - the battens should be installed in each row of tiles, every 35-40 cm.

Note: The above information is the result of collected information and our experience. The above information should not be considered as installation instructions. The use of roof communication should be in accordance with the technical design prepared for the building, taking into account the requirements of relevant standards and applicable technical and construction regulations. To add additional brackets to the kit, use the menu of individual items.

Chimney Sweep Bench Bracket - is designed for installation on tile roofs. It is a load-bearing element of the chimney batten or roof slope. The bracket is attached directly to the metal roofing through the batten to the rafters. Fastening screws ø8 must be selected so that their length significantly exceeds the thickness of the batten. To avoid breaking the roofing seal, the screws must be used with a sealing washer, and the mounting holes must be additionally sealed with asphalt, silicone or other sealant. Footbridge brackets should be installed at a distance of at least 800 mm and at every possible connection of chimney grilles with fasteners.